學習啦 > 學習電腦 > 操作系統 > Linux教程 > linux的ifconfig命令輸出結果

linux的ifconfig命令輸出結果

時間: 佳洲1085 分享

linux的ifconfig命令輸出結果

  Linux下ifconfig命令是查看網卡的信息,輸出結果要怎么看呢?下面由學習啦小編為大家整理了linux下ipconfig命令輸出結果,希望對大家有幫助!

  ipconfig命令輸出結果分析

  1、linux下ifconfig命令查看網卡的信息結果分析

  ifconfig [Interface]

  Interface是可選項,如果不加此項,則顯示系統中所有網卡的信息。如果添加此選項則顯示所指定的網卡信息

  例如:ifconfig eth0

  [plain] view plain copyeth0 Link encap:Ethernet

  HWaddr 00:0C:29:F3:3B:F2

  inet addr:192.168.0.10 Bcast:192.168.0.255 Mask:255.255.255.0

  UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

  RX packets:78 errors:0 dropped:0 overruns:0 frame:0

  TX packets:104 errors:0 dropped:0 overruns:0 carrier:0

  collisions:0 txqueuelen:100

  RX bytes:11679 (11.4 Kb)

  TX bytes:14077 (13.7 Kb)

  Interrupt:10 Base address:0x1080

  我們可以看到

  第一行:連接類型:Ethernet(以太網)HWaddr(硬件mac地址)

  第二行:網卡的IP地址、子網、掩碼

  第三行:UP(代表網卡開啟狀態)RUNNING(代表網卡的網線被接上)MULTICAST(支持組播)MTU:1500(最大傳輸單元):1500字節

  第四、五行:接收、發送數據包情況統計

  第七行:接收、發送數據字節數統計信息。

  2、ifconfig命令配置網卡結果

  配置網卡的IP地址

  ifconfig eth0 192.168.0.1 netmask 255.255.255.0

  在eth0上配置上192.168.0.1 的IP地址及24位掩碼。若想再在eth0上在配置一個192.168.1.1/24 的IP地址怎么辦?用下面的命令

  ifconfig eth0:0 192.168.1.1 netmask 255.255.255.0

  這時再用ifconifg命令查看,就可以看到兩個網卡的信息了,分別為:eth0和eth0:0。若還想再增加IP,那網卡的命名就接著是:eth0:1、eth0:2...想要幾個就填幾個。ok!

  配置網卡的硬件地址

  ifconfig eth0 hw ether xx:xx:xx:xx:xx:xx

  就將網卡的硬件地址更改了,此時你就可以騙過局域網內的IP地址邦定了。

  將網卡禁用

  ifconfig eth0 down

  將網卡啟用

  ifconfig eth0 up

  ifconfig 命令的功能很強大,還可以設置網卡的MTU,混雜模式等。就不一一介紹了,用時間可以自己研究一下。

  注意:用ifconfig命令配置的網卡信息,在網卡重啟后機器重啟后,配置就不存在。要想將上述的配置信息永遠的存的電腦里,那就要修改網卡的配置文件了。

  網絡接口配置文件

  [root@localhost ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth0

  # Intel Corporation 82545EM Gigabit Ethernet Controller (Copper)

  TYPE=Ethernet #網卡類型

  DEVICE=eth0 #網卡接口名稱

  ONBOOT=yes #系統啟動時是否自動加載

  BOOTPROTO=static #啟用地址協議 --static:靜態協議 --bootp協議 --dhcp協議

  IPADDR=192.168.1.11 #網卡IP地址

  NETMASK=255.255.255.0 #網卡網絡地址

  GATEWAY=192.168.1.1 #網卡網關地址

  DNS1=10.203.104.41 #網卡DNS地址

  HWADDR=00:0C:29:13:5D:74 #網卡設備MAC地址

  BROADCAST=192.168.1.255 #網卡廣播地址

  重新導入ifcfg-eth0網絡配置文件

  [root@localhost ~]# /etc/init.d/network reload

  Shutting down interface eth0: [ OK ]

  Shutting down loopback interface: [ OK ]

  Bringing up loopback interface: [ OK ]

  Bringing up interface eth0: [ OK ]

  網卡接口關閉與激活

  [root@localhost ~]# ifdown eth0 #關閉網絡

  [root@localhost ~]# ifup eth0 #啟動網絡

  網絡服務啟動與關閉

  方法一:

  [root@localhost ~]# service network stop #關閉網絡服務

  [root@localhost ~]# service network start #啟動網絡服務

  [root@localhost ~]# service network restart #重啟網絡服務

  方法二:

  [root@localhost ~]# /etc/init.d/network stop

  [root@localhost ~]# /etc/init.d/network start

  [root@localhost ~]# /etc/init.d/network restart

  網卡狀態查詢

  [root@localhost ~]# service network status

  Configured devices:

  lo eth0

  Currently active devices:

  lo eth0

  臨時配置網卡信息,無需重啟。

  [root@localhost ~]# ifconfig eth0 10.1.1.10 netmask 255.0.0.0

  查看網卡接口信息,默認列出所有接口

  [root@localhost ~]# ifconfig

  eth0 Link encap:Ethernet HWaddr 00:0C:29:13:5D:74

  inet addr:192.168.1.11 Bcast:192.168.1.255 Mask:255.255.255.0

  inet6 addr: fe80::20c:29ff:fe13:5d74/64 Scope:Link

  UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

  RX packets:413 errors:0 dropped:0 overruns:0 frame:0

  TX packets:572 errors:0 dropped:0 overruns:0 carrier:0

  collisions:0 txqueuelen:1000

  RX bytes:47701 (46.5 KiB) TX bytes:64842 (63.3 KiB)

  Base address:0x2000 Memory:d8920000-d8940000

  lo Link encap:Local Loopback

  inet addr:127.0.0.1 Mask:255.0.0.0

  inet6 addr: ::1/128 Scope:Host

  UP LOOPBACK RUNNING MTU:16436 Metric:1

  RX packets:407 errors:0 dropped:0 overruns:0 frame:0

  TX packets:407 errors:0 dropped:0 overruns:0 carrier:0

  collisions:0 txqueuelen:0

  RX bytes:70759 (69.1 KiB) TX bytes:70759 (69.1 KiB)

  查看當前路由及網關信息

  [root@localhost ~]# netstat -r

  Kernel IP routing table

  Destination Gateway Genmask Flags MSS Window irtt Iface

  192.168.1.0 * 255.255.255.0 U 0 0 0 eth0

  169.254.0.0 * 255.255.0.0 U 0 0 0 eth0

  default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0

  DNS:

  主機名:CentOS

  主DNS:202.106.46.151

  第二DNS:202.106.0.20

  第三DNS:8.8.8.8

3629847